Jaw turning fixtures simulate the locating pattern of standard air chucks. They are used to rough turn blank top jaws off the chuck. It is recom mended that jaws be finished bored on the chuck for best accuracy.
The clamping position of the jaw turning fixture is set in the middle of the chuck's stroke. Other positions are available upon request. Specify chuck model when ordering.
Unit of Measure
Chuck |
N/A 8 inch |
Outside Dia. |
N/A 8.5 in216 mm |
Thickness |
N/A 1.25 in31.7 mm |
Ordering Information |
N/A
Model of chuck must be specified when ordering. |
Item No. |
N/A 11 030 XXX |
